مقاله انگلیسی رایگان در مورد بررسی تأثیر کنترل توان راکتیو سیستم های فتوولتائیک روی شبکه ها – الزویر ۲۰۲۰

مقاله انگلیسی رایگان در مورد بررسی تأثیر کنترل توان راکتیو سیستم های فتوولتائیک روی شبکه ها – الزویر ۲۰۲۰

 

مشخصات مقاله
ترجمه عنوان مقاله بررسی تأثیر کنترل توان راکتیو سیستم های فتوولتائیک بر روی شبکه های توان الکتریکی و ایجاد یک روش تنظیم ولتاژ که حساسیت مقاومت به فیدر را در نظر می گیرد
عنوان انگلیسی مقاله Examination of the effect of the reactive power control of photovoltaic systems on electric power grids and the development of a voltage-regulation method that considers feeder impedance sensitivity
انتشار مقاله سال ۲۰۲۰
تعداد صفحات مقاله انگلیسی ۱۰ صفحه
هزینه دانلود مقاله انگلیسی رایگان میباشد.
پایگاه داده نشریه الزویر
نوع نگارش مقاله
مقاله پژوهشی (Research Article)
مقاله بیس این مقاله بیس نمیباشد
نمایه (index) Scopus – Master Journals List – JCR
نوع مقاله ISI
فرمت مقاله انگلیسی  PDF
ایمپکت فاکتور(IF)
۳٫۷۸۲ در سال ۲۰۱۹
شاخص H_index ۱۰۴ در سال ۲۰۲۰
شاخص SJR ۱٫۰۳۷ در سال ۲۰۱۹
شناسه ISSN ۰۳۷۸-۷۷۹۶
شاخص Quartile (چارک) Q1 در سال ۲۰۱۹
مدل مفهومی ندارد
پرسشنامه ندارد
متغیر ندارد
رفرنس دارد
رشته های مرتبط برق
گرایش های مرتبط سیستم های قدرت، برق قدرت، الکترونیک، انتقال و توزیع، الکترونیک قدرت
نوع ارائه مقاله
ژورنال
مجله  تحقیقات سیستم های قدرت الکتریکی – Electric Power Systems Research
دانشگاه Electrical Engineering, Inha University, Incheon, 22212, South Korea
کلمات کلیدی تولید پراکنده (DG)، سیستم های فتوولتائیک (PV)، کنترل توان راکتیو، OpenDSS، کنترل ولتاژ و وار
کلمات کلیدی انگلیسی Distributed generation (DG)، Photovoltaic (PV) systems، Reactive power control، OpenDSS، Volt/Var control
شناسه دیجیتال – doi
https://doi.org/10.1016/j.epsr.2019.106130
کد محصول E14475
وضعیت ترجمه مقاله  ترجمه آماده این مقاله موجود نمیباشد. میتوانید از طریق دکمه پایین سفارش دهید.
دانلود رایگان مقاله دانلود رایگان مقاله انگلیسی
سفارش ترجمه این مقاله سفارش ترجمه این مقاله

 

فهرست مطالب مقاله:
Abstract

۱- Introduction

۲- Problem statement

۳- Reactive power control

۴- Volt/Var control

۵- Conclusions

References

بخشی از متن مقاله:

Abstract

When relatively high-capacity renewable photovoltaic (PV) systems are connected to a grid, they can increase or decrease the voltage along feeders because of reverse power flow, even exceeding ± five percent of the rated voltage. Nowadays, grid-connected inverter-based PV systems that can control reactive power can alleviate such an increase or decrease in voltage by adjusting the reactive power, which is referred to as Volt/Var control and management. Therefore, the objective of this paper is to (a) perform case studies to analyze the steady-state response of a large distribution network (i.e., with more than 1000 buses) with high-capacity PV systems that can control Volt/Var (i.e., either producing or consuming reactive power) and (b) present a Volt/Var-control method for three-phase voltage regulation that uses the positive-sequence sensitivity impedance matrix with power-factor constraints. This method is verified in the IEEE 34-bus test feeder. Thus, the proposed methods can be used to regulate the voltage of a bus to which a PV system is connected if the system controls reactive power. These proposed methods can also be used for various impact studies for the operation or planning of distribution systems with such PV systems.

Introduction

Photovoltaic (PV) systems with a capacity from tens to thousands of kW that are connected to a distribution network below 30 kV can reduce losses and daytime peak demand, which is known as peak load shaving. However, if these systems are not adequately regulated, they can increase or decrease the voltage because of reverse power flow. Thanks to inverters that can control reactive power, modern inverterbased PV systems that are connected to grids can actively control reactive power, which is referred to as Volt/Var control and management. However, the connection of such PV systems to grids requires mutually well-coordinated voltage-regulation agreements between utilities and PV owners (or PV operators) if the PV systems regulate voltage. In fact, variations in the power output from PV systems can be regulated by utilities so that the feeder voltage can be maintained within a set range of the rated voltage (i.e., ANSI C84.1–۲۰۱۶ Range A [1] or EN 50160 [2]). In addition to voltage regulation, a distribution network that hosts PV systems should be able to detect abnormal or limited conditions according to the voltage ranges and clearing times, as presented in [3,4]. Furthermore, settings for dynamic or static voltage regulation can be allowed only under mutual agreement between PV owners and utilities [3,4].

ثبت دیدگاه