مقاله انگلیسی رایگان در مورد نظریه ای برای سنتز مبدل های غیر منفرد DC-DC با استفاده از اصل تعادل شار – ۲۰۱۹ IEEE

مقاله انگلیسی رایگان در مورد نظریه ای برای سنتز مبدل های غیر منفرد DC-DC با استفاده از اصل تعادل شار – ۲۰۱۹ IEEE

 

مشخصات مقاله
ترجمه عنوان مقاله نظریه ای برای سنتز مبدل های غیر منفرد DC-DC با استفاده از اصل تعادل شار
عنوان انگلیسی مقاله A Theory to Synthesize Non-isolated DC-DC Converters using Flux Balance Principle
انتشار مقاله سال ۲۰۱۹
تعداد صفحات مقاله انگلیسی ۱۶ صفحه
هزینه دانلود مقاله انگلیسی رایگان میباشد.
پایگاه داده نشریه IEEE
مقاله بیس این مقاله بیس نمیباشد
نمایه (index) JCR – Master Journal List – Scopus
نوع مقاله ISI
فرمت مقاله انگلیسی  PDF
ایمپکت فاکتور(IF)
۸٫۵۵۴ در سال ۲۰۱۹
شاخص H_index ۲۲۲ در سال ۲۰۲۰
شاخص SJR ۲٫۵۱۰ در سال ۲۰۱۹
شناسه ISSN ۰۸۸۵-۸۹۹۳
شاخص Quartile (چارک) Q1 در سال ۲۰۱۹
مدل مفهومی ندارد
پرسشنامه ندارد
متغیر دارد
رفرنس دارد
رشته های مرتبط برق
گرایش های مرتبط مهندسی الکترونیک، مدارهای مجتمع الکترونیک، الکترونیک قدرت و ماشینهای الکتریکی
نوع ارائه مقاله
ژورنال
مجله  نتایج بدست آمده در حوزه الکترونیک قدرت – Transactions on Power Electronics
دانشگاه Department of Electrical Engineering, Indian Institute of Technology Delhi, New Delhi, India
کلمات کلیدی مبدل های DC-DC، سنتز مبدل، معادله تعادل شار
کلمات کلیدی انگلیسی DC-DC converters، Synthesis of converter، Flux Balance equation
شناسه دیجیتال – doi
https://doi.org/10.1109/TPEL.2019.2898702
کد محصول E13309
وضعیت ترجمه مقاله  ترجمه آماده این مقاله موجود نمیباشد. میتوانید از طریق دکمه پایین سفارش دهید.
دانلود رایگان مقاله دانلود رایگان مقاله انگلیسی
سفارش ترجمه این مقاله سفارش ترجمه این مقاله

 

فهرست مطالب مقاله:
Abstract

I- Introduction

II- Fundamental Assumptions

III- Inductor Voltage Equation

IV- First-Order Converters

V- Second-Order Converters

References

 

بخشی از متن مقاله:

Abstract

The paper describes a theory to synthesize nonisolated DC-DC converters. It uses the fundamental flux balance equation across the inductors of a converter as a starting point in this synthesis process. The flux balance equations are the linear equations of the input voltage, capacitor voltages and duty cycle (D). The coefficients of these linear equations can be selected from a finite set of choices. These choices define the converter topologies which are subsequently used to synthesize a converter. The synthesis procedure applies to a converter of multiple order. All the possible converters are identified for a first order topology. In the case of second-order converters, all the choices of the flux balance equation are defined. Based on these choices three new quadratic topologies are derived and verified to demonstrate the effectiveness of the theory. The procedure to synthesize a converter from a given voltage conversion ratio is also outlined.

INTRODUCTION

Non-isolated DC-DC converters are the basic building blocks for power processing in renewable applications, data centers, and various consumer electronics devices, etc. Buck, Boost, and Buck-boost topologies are the three major topologies which are manipulated to obtain other non-isolated topologies [1-17]. With increasing novel areas of application, there is a need to look for DC-DC converters with a given voltage conversion characteristic. For example, quadratic buck (Q buck) converter provides a very low output to input conversion ratio at a relatively higher duty-cycle [12-13], which makes it suitable for bias voltage derivation when input DC is very high. Mostly, converter topologies are invented intuitively or by combining the existing basic topologies of buck, boost, and buck-boost converter. However, a systematic procedure to synthesize a converter topology from the required voltage conversion ratio is scarce. This paper presents a thorough review of the prior attempts to generalize DC-DC converter synthesis process and subsequently proposes a method to synthesize the exhaustive set of DC-DC converters of a given order. While many DC-DC converters have been invented over the past few decades, there has been a constant drive among the researchers to find a unifying link among the different DC-DC converter topologies and find a generalized converter synthesis theory. Many such approaches such as graph-theoretic approach with duality principle [1], [2], converter switching cell theory [3], [4], [5], [6], analytical synthesis theory [7], [8], and converter synthesis with layer and graft schemes [9-11], etc., are presented in the literature. The graph-theoretic approach was used in [1] to establish a relation between basic Pulse Width Modulated (PWM) converters [1-7, 18-22].

ثبت دیدگاه