مقاله انگلیسی رایگان در مورد فرسودگی اتصالات جوش داده شده – الزویر 2018

1. Introduction

2. Fatigue of Welded Joints in API 579-1/ASME FFS-1

3. Ratcheting

4. Fatigue Assessment of Welds Using the Equivalent Structural Strain Method

5. Summary

Acknowledgements

Appendix A. Derivation of the Structural Strain Method

References

The 3rd Edition of API 579-1/ASME FFS-1 2016 Fitness-For-Service includes a new Part 14 dedicated to fatigue assessment. An important section in this part covers the fatigue assessment of welded joints. In this paper, an overview of the fatigue methods for welded joints is provided and extensions are recommended. First, an overview is given of the classical fatigue method used in the ASME B&PV Code based on smooth bar fatigue curves in conjunction with a fatigue strength reduction factor. In addition, the mesh insensitive structural stress method is outlined using an equivalent stress parameter based on fracture mechanics considerations in conjunction with a master S-N curve based on the analysis of over 2000 high and low cycle S-N test data. The resulting master S-N curve approach is applicable to high cycle fatigue and low cycle fatigue if a Neuber correction is introduced. In this paper, a new structural strain method is presented to extend the early structural stress based master S-N curve method to the low cycle fatigue regime in which plastic deformations can be significant while an elastic core is present. With this new method, some of the inconsistencies of the pseudo-elastic structural stress procedure can be eliminated, such as its use of Neuber’s rule in approximating structural strain beyond yield. The earlier mesh-insensitive structural stress based master S-N curve method can now be viewed as an application of the structural strain method in the high cycle regime, in which structural strains are linearly related to traction-based structural stresses according to Hooke’s law. Thus, both low cycle and high cycle fatigue behavior can now be treated in a unified manner. In the low-cycle regime, the structural strain method characterizes fatigue damage directly in terms of structural strains that satisfy a linear through-thickness deformation gradient assumption, material nonlinear behavior, and equilibrium conditions. A PVRC Joint Industry Project is currently sponsoring work on the structural strain method that will lead to its incorporation in the next edition of API 579-1/ASME FFS-1.

Introduction

In a previous paper, Osage [1] provides an overview of the third edition of API 579-1/ASME FFS-1 Fitness-ForService that was published in 2016. The 2016 Edition includes a new Part 14 covering fatigue assessment procedures for in-service components. Fitness-For-Service (FFS) assessments are quantitative engineering evaluations that are performed to demonstrate the structural integrity of an in-service component that may contain a flaw or damage, or that may be operating under a specific condition that might cause a failure. The API 579- 1/ASME FFS-1 Standard was specifically written to cover in-service pressurized equipment typically found in the refining and petrochemical industries as well as the fossil utility industry. Part 14 provides methods used to estimate the time to crack initiation using a strain-life approach and is written as a multi-level approach covering screening, current design code methods, and advanced methods that take into account the latest in technology. The advanced methods include fatigue assessment of welded joints using the equivalent structural strain and Master S-N Curve Method and a new smooth-bar fatigue assessment method that incorporates a multi-axial fatigue criterion with a critical plane approach. Cycle counting methods for both welded joint and smooth-bar fatigue methods are also provided. Methods to evaluate fatigue in the subcritical crack-growth regime in API 579-1/ASME FFS-1 using a fracture mechanics approach are also covered.